MaterialSetupRequirement Class |
[This is preliminary documentation and is subject to change.]
Describes a single, specific material setup requirement at a particular process endpoint.
Includes the material / part that must be loaded at the endpoint, along with the
specific location where the material must be loaded (where applicable), valid alternate
part numbers that may be substituted for the primary part, and any applicable
AML (Approved Manufacturer List) restrictions.
Inheritance HierarchyNamespace: CFX.Structures
Assembly: CFXnet46 (in CFXnet46.dll) Version: 1.0.5
SyntaxThe MaterialSetupRequirement type exposes the following members.
Properties| Name | Description | |
|---|---|---|
 | ApprovedAlternateParts |
An optional list of approved alternate parts (internal part numbers) that may be substituted
for the primary part.
|
| ApprovedManufacturerParts |
An optional list of specific manufacturer part numbers that must be utilzed. When specified,
a part will only be acceptable if both its internal part number matches the PartNumber property (or Alternates),
AND its manufacturer part number matches one of the parts specified in the ApprovedManufacturerParts property.
|
| PartNumber |
The internal part number of the part that must be loaded at this position.
|
| Position |
The position where the required material must be installed on the Endpoint (optional).
Where applicable, a dot (".") notation should be utilized to designate
specific positions. Examples: MODULE1.FRONT.Pos23, STAGE2.BANK1.Pos44, etc.
|
See Also